Knowledgebase

This Article is for the Kuberg Freerider, Freerider street, Challenger and X-Force. Make sure that you are following the correct charging procedure, you can find a copy of this in the manual that came with your bike, or you can download a digital copy at https://www.kuberg.com/en/owners-manual ...

Because we ship our bikes worldwide, we have taken measures to ensure safe transportation. One of these measures is to disconnect the battery from the bike, (only in Kuberg bikes with Li-ion batteries) This means that when you receive your bike, it will not run automatically unless your dealer ha...

With older batteries, or batteries that haven't been charged or looked after properly, the battery's plates can become coated with lead sulphate, this means the batteries aren’t able to charge to capacity. When this happens the bike will charge as normal, once the batteries are full (or what the...

This article is for the Kuberg Freerider, X-Force, Challenger & Freerider Street The axle in the motor can become damaged or snap through excessively hard and sporadic acceleration, an overly tight or slack chain, and hard knocks, falls or landings. We are constantly developing our technology...

Please open the QUICK START GUIDE that came attached to your bike, you should find the serial number in there.The serial number will also be on a label on the side of the box your Freerider was delivered in.If you no longer have either of these then you will also be able to find the serial number o...

The Domino throttle uses a potentiometer. A potentiometer is a variable resistor--a device used to resist the flow of electric current. As you turn the potentiometer, it increases or decreases the resistance. The resistance of the potentiometer is around 5.2 Ohms You can find the resistance of y...

Changing the oil seal is very easy on the dorado: Required tools: Tire lever ( big one ) steel ( not plastic ) Dorado seal press 36mm socket or open end wrench 12mm open end wrench 13mm open end wrench 5mm allen key 6mm allen key 4mm allen key Screwdriver flat ( small ) Proce...

CHAIN TENSION YOU WILL NEED 10mm 19mm 22mmStool or Degreaser Chain Old cloth work stand lubrication or rag ALSO USEFUL 1 First, make sure that the power is turned off.2 Secure your bike on a stool or stand, loosen the bolts on the rear wheel (it is not necessary to remove them), the drive s...